When we think about saving energy at home in winter, we usually think about the thermostat. But there’s another big energy user quietly working in the background: the water heater. Every hot shower, load of laundry and sink full of dishes takes energy to heat.
The good news is that a few simple habits can trim that energy use without cold showers or sacrifice. Here are eight greener ways to use less energy heating water this winter.
1. Check your water heater temperature
Many water heaters are set hotter than needed. The U.S. Department of Energy suggests that 120°F (about 49°C) is enough for most households. Lowering the setting reduces the energy used to keep the tank hot and can lower the risk of scalding.
Check your heater’s label or manual for how to adjust it safely, and talk to a professional if you’re unsure. Some households, such as those with certain health needs or dishwashers without a booster heater, may need a different setting.
2. Take slightly shorter showers
Showers are one of the biggest uses of hot water in most homes. Cutting a couple of minutes from each shower adds up quickly across a household. Try a favorite song as a timer: when it ends, so does the shower.
3. Install a low-flow showerhead
Modern water-saving showerheads use less water per minute while still feeling comfortable. Look for the EPA’s WaterSense label, which identifies products that meet water-efficiency and performance standards. Swapping one is usually a simple DIY job with a wrench and some plumber’s tape.
4. Wash clothes in cold water
Much of the energy used by a washing machine goes to heating water. Today’s detergents are designed to work well in cold water for everyday loads. Save warm or hot cycles for heavily soiled items or bedding that needs extra care.
As a bonus, cold washes are gentler on many fabrics and help colors last longer.
5. Run full loads
Whether it’s the dishwasher or the washing machine, running full loads means you heat less water per dish or per shirt. Many dishwashers also use less water than hand-washing a big pile under a running tap, especially if you skip pre-rinsing and just scrape plates.
6. Fix leaky hot water taps
A dripping hot water faucet wastes both water and the energy used to heat it. Often the fix is a worn washer or cartridge, which is an inexpensive part. If you’re handy, it’s a straightforward repair; if not, a plumber can usually fix it quickly.
7. Insulate what you can
Heat escapes from hot water pipes as water travels to your taps. Foam pipe insulation is cheap and easy to slip onto exposed pipes, especially near the water heater, in basements or in crawl spaces. It helps water arrive hotter, so you spend less time waiting with the tap running.
Some older tank water heaters may also benefit from an insulating blanket. Check your manufacturer’s guidance first, since many newer tanks are already well insulated and some models shouldn’t be wrapped.
8. Maintain your water heater
Sediment can build up in the bottom of a tank water heater over time, making it work harder. Many manufacturers recommend periodic flushing. Check your manual for instructions, or have it done during a routine service visit.
If your water heater is nearing the end of its life, it’s worth researching more efficient replacements, such as heat pump water heaters, before it fails. Planning ahead gives you time to compare options instead of rushing into a replacement in an emergency.
Small changes, real impact
None of these steps requires a major renovation. Together, they reduce the energy your home uses every day, which can mean lower bills and a smaller environmental footprint. Pick two or three to start, like lowering the temperature, washing in cold water and adding pipe insulation, and build from there.
The bottom line
Hot water is one of the comforts of winter, and you don’t have to give it up to live greener. A few smart settings and simple habits let you keep the warmth while wasting less energy. Which of these changes will you try first?
Image: Shower Fixture 2.0 by cogdogblog via Flickr, CC0 1.0